Change a Propane Tank
Propane powered forklifts are commonly utilized inside warehouses. The forklift is made with the propane tank mounted at the rear of the operator. The tanks, which look a lot like beer kegs, have to be replaced from time to time since they have a limited lifespan. Drivers of forklifts must utilize care when handling propane tanks. Compressed gases are really hazardous, specially since the gas is flammable. Always use caution when removing and replacing propane tank to avoid being injured.
1 To change a propane tank, first stop the lift truck and leave the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This procedure burns the gas off inside the transfer hose that connects the tank and the engine. Before taking the second steps, wear the proper safety equipment, like insulated gloves made of either leather or neoprene. It is very essential for you to protect your skin from contact with the compressed gas, which is extremely cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, tighten the nut to reconnect the holding straps and to reattach the hose at the valve of the tank.
3 You could inspect for leaks by applying soapy water to the valve and opening it slightly. Leaking gas will cause bubbles to froth around the value. If this occurs, inspect the valve area and the connection hose at the nut. The connecting nut should be re-tightened if you detect any leaks around the area of the valve, and afterward perform the leak inspection process again. Persistent leaks mean that the connecting hose and nut must be replaced. Nevertheless, if replacing the nut and hose still does not stop the leak, the tank should be replaced.
4 Finally, open the valve all the way to allow the gas to fill the connecting hose. Afterward you can start the lift truck and continue operating.